Voice Center™Conference PhoneModel CP-2012User's Manual
4. Use Digital Interface’s 4-position switch to adjust audio level bymaking a test call.• Lift digital telephone handset from its cradle, then pressCo
Keypad Functions with Digital Phone SystemON/OFFPressing the ON/OFF key turns the Conference Phone on to connect a call, or turns it off toterminate t
Conference Phone Operation with Digital Phone SystemAnswering a call1. When the phone rings, pick up the digital telephone handset to accept the call.
General Setup TipsTips for Obtaining Optimal Acoustic Performance• To minimize echoes, place the Conference Phone at the center of the room, or at lea
'ENERAL)NSTALLATIONOF%XTERNAL-ICROPHONES/PTIONAL4HE6OICE#ENTER#ONFERENCE0HONEHASBUILTINMICROPHONESFORCOMPLETE COVERAGEINA
SpecificationsConference PhoneControls and InterfaceSwitches Microphone switch to turn on Tone/pulse switch to select2, 3 or all 4 built-in microphon
Spracht Limited Warranty PolicySpracht warrants it products against defects or malfunctions in material and workmanship under normal use and service,
Federal Communications Commission StatementNote: The Voice Center Conference Phone equipment has been tested and found to comply with the limits for a
SPRACHTTel: 650-318-8061Fax: 650-318-80602672 Bayshore Parkway, Bldg 900Mountain View, CA 94043 USAwww.spracht.com© 2003 Spracht Spracht and Voi
Table of Contents - Voice Center User’s ManualIntroduction and Quick Start GuidePackage Contents. . . . . . . . . . . . . . . . . . . . . . . . . . .
IntroductionThank you for choosing the Voice Center Conference Phone, a high performance audio conferencing system.Its features include:• Full duplex
3Quick Start Guide3. Analog or Digital Telephone System?Caution: if the Voice Center is connected to a digital telephone system using the AnalogTeleph
Analog Telephone SystemSetup with Analog Telephone SystemIf you are connecting the Voice Center Conference Phone to an analog telephone system, follow
Wall Mounting of Analog Interface (Optional)• Install the two mounting screws supplied with the Analog Interface in thewall. Leave approximately 3/16
Keypad Functions with Analog Phone SystemON/OFFPressing the ON/OFF key turns the Conference Phone on to obtain a dial tone, or turns it off toterminat
Conference Phone Operation with Analog Phone SystemAnswering a callWhen the Conference Phone rings, press the ON/OFF key to answer the call. The green
Digital Telephone System Setup of Conference Phone with Digital Phone System Note: The DT-104 Digital Telephone System Interface is required for use o
Commentaires sur ces manuels